Designed specifically to power the ButtKicker^® , the BKA1000-4A is an incredible value, chock full of features designed to make the installation and operation of the ButtKicker^®  easier and more affordable.

Easier:  No preamplifier is required.  For home theater, just use a RCA cable to go from your processor's subwoofer out* to the RCA input on the ButtKicker^®  Amplifier.  Then, use 12 gauge speaker wire from the amplifier to the ButtKicker^® .  It's as simple as that - plug 'n play.

* Use a "Y" connector if your processor has only one sub out.

More Affordable:

With 1000 watts into 4 ohms and 1900 watts into 2 ohms, the BKA1000-4A is able to power one or two 4 ohm ButtKicker^®  Shakers (when wired in parallel).  Wiring diagrams...

More Value:

Low cutoff and variable high cutoff filters!.. Not only does the ButtKicker^®  Amplifier have over 1900 watts of power at 2 ohms, it adds low and high cutoff filters at no additional cost.

With the low cutoff in the "on" position frequencies less than 25 Hz are filtered out.  This is ideal for musicians who do not need nor want the ButtKicker^®  Shaker to "see" anything below 25 Hz.  When the low cutoff is in the "off" position all frequencies are passed on the ButtKicker^®  - ideal for home theater use and the low frequency response the ButtKicker^®  has become known for.

Variable high cutoff filter:

With the high cutoff in the "on" position, frequencies above 40 to 160 Hz are filtered out - meaning only frequencies below 40 to 160 Hz are passed to the ButtKicker^® .  The variable high cutoff filter control allows you to set the high cutoff from 40 to 160 Hz.  This is ideal for home theater use when only low frequencies are wanted.  Conversely, when used by musicians, leaving the high cutoff switch in the "off" position enables the ButtKicker^®  to respond to all frequencies in its natural working range of 5 - 200 Hz.

ButtKicker^®  Amplifier Specifications

• Model #: BKA1000-4A

• 1000 Watts @ 4 ohms

• 1900 Watts @ 2 ohms - will  power 2 ButtKicker^®  wired in parallel

• Class D switching technology

• Variable high cutoff, 40 to 160 Hz

• Low cutoff, 25 Hz switch-able

• RCA and ¼” inputs with 160mVolt and 1.25 Volt sensitivities eliminates the need for a separate pre-amplifier

• Touch proof binding post output

• 120v standard, 240v available upon request

• Convection cooling, i.e. no fan

• 12"W x 11"L x 4.375"H,

• 23 lbs / 10.5 kg